|No Of Phase||2|
The DMA860E is a digital stepper drive with simple design and easy setup. By implementing Leadshine advanced stepper control technology, this stepper drive is able to power 2-phase and 4 phase stepper motors smoothly with optimal torque and low motor heating & noise. Its operating voltage is 18-80VAC or 24-110VDC and it can output up to 7.2A current. All the micro step and output current are done via DIP switches. Therefore, the DMA860E are ideal choices for applications requiring simple step & direction control of NEMA 23, 24, 34, and 42 stepper motors.
Anti-Resonance for optimal torque, smooth motion, low motor heating and noise.
Motor auto-identification and parameter auto-configuration for optimal torque from wide-range motors.
Step & direction (PUL/DIR) and CW/CCW (via internal jumper set) control. Step & direction by default Multi-Stepping for smooth motor movement.
Opto Isolation for input control signals.
Input voltage 18-80VAC or 24-110VDC.
16 selectable micro-step resolutions of 400-51,200 via DIP switches.
8 selectable output current settings of 2.4 – 7.2A via DIP switches.
Soft-start with no “jump” when powered on.
Pulse input frequency up to 200 KHz. TTL compatible and optically isolated inputs.
Automatic idle-current reduction.
Protections for over-voltage and over-current.
Control Mode: Step & Direction
Max Input Frequency: 200KHz
Input Voltage Range: 18 - 80 VAC / 24 - 110 VDC
Suggested Power Supply Voltage Range: 36-90 VDC /24-60 VAC
# of DIP Switch Resolution Configurations: 16
DIP Switch Resolution Setings: 400, 800, 1600, 3200, 6400, 12800, 25600, 51200, 1000, 2000, 4000, 5000, 8000, 10000, 20000, 40000
# of DIP Switch Current Configurations: 8
DIP Switch Current Configurations: 2.40A, 3.08A, 3.77A, 4.45A, 5.14A, 5.83A, 6.52A, 7.20A
Logic Current Range: 7-16mA (10mA typical)
Logic Voltage Range: 4-5 VDC for pulse active high (default) , or 0-0.5V for pulse active low
Pulse enabled at: Rising edge
Idle Current Percentage: 50 %
# of Digital Inputs: 3
Step Width: 2,500 ns
Minimal Direction Setup Time: 5,000 ns
Isolation Resistance: 500M Ohm
Environment: Avoid dust, oil fog and corrosive gases
Ambient Temporature: 0-50°C
Humidity: 40–95% RH
Operating Temporature: 0-70°C
Vibration: 5.9 m/s2 Max
Storage Temporature: -20-65°C
Specification: 5.94 X 3.82 X 2.24 Inches
Weight: 1.13 lbs
Digital Stepper Motor Driver, Leadshine Stepper Motor, Leadshine DMA860E Digital Stepper Driver, Leadshine Stepper Driver DC 24-80V, 7.2A Stepper Motor Driver 24-80V , Stepper Driver DC24-80V for 86/110 2 phase Stepper